Hallowing Cyclops Cranium « Adafruit Industries – Makers, hackers, artists, designers and engineers!


3d print technology news

3d Print

Hallowing Cyclops Cranium « Adafruit Industries – Makers, hackers, artists, designers and engineers!


Hallowing Cyclops Cranium « Adafruit Industries – Makers, hackers, artists, designers and engineers!ca74b15498e8b4dcad018e37325f7d39_preview_featured-600x451

through Littlefiver on Thingiverse

Simply in time for Halloween!

Anyhow, utilizing the Adafruit “Lens” cowl I had printed, I remix the cyclops cranium from I-see-3D to be glued on high with the lens connected. There’s additionally a reduce out for the sunshine sensor. I painted this PLA print with acrylic paint (a primary for me), and sealed it.

Blissful Halloween.

Notice: I’m additionally utilizing the Battery Case by DoctorWhich. Undecided why, however the lens doesn’t match the “Lens” cowl when utilizing the battery case. (I didn’t attempt it with the Adafruit again) That’s the reason I made the cranium to suit the lens.

Read more!


Featured Adafruit Merchandise!

Hallowing Cyclops Cranium « Adafruit Industries – Makers, hackers, artists, designers and engineers!ca74b15498e8b4dcad018e37325f7d39_preview_featured-600x451

Adafruit HalloWing M0 Express
Are you the sort of one that doesn’t like taking down the skeletons and spiders till after January? Effectively, we’ve acquired the event board for you. That is electronics at its most spooky! The Adafruit HalloWing is a skull-shaped ATSAMD21 board with a ton of extras inbuilt to make for an lovely wearable, badge, growth package, or the engine in your subsequent cosplay or prop.
Read more.